The Emsco FA-1300 is a horizontal triplex single-acting piston mud pump rated by factory data at 1300 HP input power, with a 12 in stroke, a rated speed of 120 SPM and a maximum working pressure of 5000 PSI. The combination of a long stroke and a moderate stroke rate helps the pump fill cleanly on the suction side and reduces wear cycles on fluid end consumables, which matters on deep wells and complex formations where the pump runs long hours at high load. Liner bore selection across the available range lets crews balance output against pressure up to the 5000 PSI ceiling. We supply replacement fluid end parts for this model to operators in Canada, the United States and international oil and gas markets.
FAQ
What are the factory ratings of the Emsco FA-1300 mud pump?
Factory data lists 1300 HP rated input power, a 12 in stroke, 120 SPM rated speed and a maximum working pressure of 5000 PSI. Maximum flow figures are available on request.
Why does the FA-1300 use a long stroke at a moderate speed?
The 12 in stroke at a rated 120 SPM improves suction filling and lowers the number of wear cycles per unit of pumped volume, which extends the service life of fluid end wear parts.
What drilling duty suits the Emsco FA-1300?
It suits deep wells and complex formations where a 5000 PSI class triplex must hold up under sustained high load, on land rigs in Canada, the United States and international markets.
Which fluid end wear parts do you supply for the FA-1300?
We supply liners, pistons, valves, valve seats, valve springs, packing, fluid end modules, valve caps and fluid end repair kits for this model.
Can you ship FA-1300 parts to Canada, the US and overseas?
Yes. We ship to Canada, the United States and international oil and gas destinations; pump parts of this type are commonly classified under HS code 84139100 for customs purposes.