The Drillmec 10T1300 is rated at 1300 HP input power with a 9 in stroke, a rated speed of 150 SPM and a max working pressure of 5000 PSI. The power end sits on an integral frame welded from high-strength low-alloy steel, and after welding the whole frame goes through a rigorous stress-relief heat treatment for long-term structural stability. Factory data lists liner bores from 4.5 in to 7 in, with maximum working pressures from 5000 PSI down to 2786 PSI depending on liner size.
FAQ
What are the factory ratings of the Drillmec 10T1300?
Factory spec data lists a rated input power of 1300 HP, a stroke length of 9 in, a rated speed of 150 SPM and a max working pressure of 5000 PSI.
Which liner sizes does factory data list for the 10T1300?
Factory data lists liners from 4.5 in to 7 in: the 7 in liner carries a max of 2786 PSI, the 6.75 in liner 2998 PSI, the 6.5 in liner 3232 PSI, the 6 in liner 3792 PSI, the 5.5 in liner 4516 PSI, and the 5 in and 4.5 in liners 5000 PSI each.
How is the 10T1300 frame constructed?
The power end uses an integral frame welded from high-strength low-alloy steel, and the entire frame is put through a rigorous stress-relief heat treatment after welding to secure rigidity and fatigue strength.
What fluid-end parts do you supply for the Drillmec 10T1300?
We supply liners, pistons, valves, valve seats, valve springs, packing and complete fluid end modules matched to the 10T1300 and to the liner bore your rig runs.
Do you export 10T1300 parts to Canada and the United States?
Yes, we ship to Canada, the United States and international oil and gas destinations. Pump parts are classified under HS code 84139100 and travel with full export documentation.